Retro Fit S.A.F.E. GATES™ Large 48″ Arm


1-50 $299.99
51+ 5% Discount
Call 1-630-362-8482


Each of the Patent Pending S.A.F.E. GATES™ products are crafted from the highest quality materials on the market today.  S.A.F.E. GATES™ are light weight to reduce any additional stress put on stop arm motors and are within/meet all manufacture specs, thus they will not reduce the life of any stop arm motor.  All S.A.F.E. GATES™products are built with every weather element in mind.  The extreme HEAT in Phoenix, the bitter Cold of Minneapolis, the WIND gusts in San Francisco, the WET and RAINY conditions of Seattle and even the unbearable HUMIDITY in Chicago are NO match from Mother Nature for the S.A.F.E. GATES™ products, they are built to last and satisfaction is 100% guaranteed!

The Patent Pending Large Retro Fit S.A.F.E. GATES™ Arm is made of high quality fiberglass that’s 4″ wide and 48″ long to create the strength and distance needed to stop vehicles in their pathway (after installation the total distance from school bus to the end of the Large S.A.F.E.GATES™ Arm stretches over 5 1/2 feet!).  The fiberglass arm allows for the flexibility needed to stand up to the daily use of the stop arm deployment.  The L.E.D. lights are 48″ long on both sides to give maximum exposer to the on coming vehicles from as far as a mile away.  L.E.D. lights are set to a continuous light stream to allow the contrast with the alternating flashing lights of the stop arm panel. The 8 feet of 3″ 3M™ reflective tape meets Federal Regulations and allows the S.A.F.E GATES™ Arm to be seen from every angle and the distance needed to warn on coming motorist of a stopped school bus ahead.  The S.A.F.E. GATES™ Large 48″ Arm is installed with the included 4 screws, 1 aluminum bolt with nylon nut and a wire connector, that’s it!  Each S.A.F.E. GATES™ Arm can be installed and ready for use within 15 minutes.  SEE INSTALLATION INSTRUCTIONS: safegatesinstall


Additional information

Weight 5 lbs
Dimensions 50 × 4 × 1 in